CAR & GOODS LIFT EVANESCO MONO

Evanesco Mono, which can be installed on a reinforced concrete wall with lateral guides, achieves high lifting coefficients and can be easily positioned inside buildings, warehouses and car dealers. The maximum travel that can be reached from the plant is about 10 m with a maximum load capacity of 3000 kg.

The car-and-elevator is made with standard solutions or customizable to specific customer needs.

Category:

Description

Race Up to 10,000 mm
Flow Up to 3,000 kg
Useful Floor Up to 6,000 x 3,000 mm
Operation Electrohydraulic
Guides Hoesch steel profiles with double carriage at the head of the piston
Attacks To wall anchoring brackets
Trolley With axial and coaxial self-lubricating bearings
Lifting Movement Double-acting with piston section to be defined
Engine

220/380 V three-phase HP 7,5 KW 5.5 or single-phase standard on request

Electric safety devices Limit stop microswitch, manual descent valve in case of power failure
Hydraulic Safety Parachute valve on the cylinder, control valve for descent speed, emergency lowering on the ground, hydraulic power unit
Mechanical Security Lifting chain, clamp system in pairs of pliers
Hydraulic unit

Made according to the most modern principles of hydraulics

Electric control unit With logic module (PLC)
Standard Speed 6-8 cm/s
Commands 24V, for present man, call buttons on the floors and \ or remote control. The controls work only if the doors of the floors or gate are closed
Hole Height 400/450 mm